Refer to the exhibit. 

Which of the following is the minimum dimension of Hallway A required to meet ADA requirements, 

if dimension (B) is 4 inches?

Refer to the exhibit. 

What is the primary function of the 2 x 4 blocking shown at X in the drawing?

a more efficient interaction between office staff, students, and parents. The following instructions are 

given to the architect: 

The renovation scope is limited to the footprint only of the existing reception office. 

Additionalstaff is not proposed forthe renovated area. 

The existing ceiling and associated fixtures will be protected from damage during construction. 

The construction of the renovation must occur during the 10-week summer break. 

Which of the following series drawings should be included in the documents set?

relative to a sawn timber beam? (Assume Fᵦ of the glue-laminated beam is 2,400 psi and Fᵦ of the 

sawn lumber beam equals 1,200 psi.)

project requires the following flooring materials: 

Stained concrete: 100,000 square feet 

Carpet: 50,000 square feet 

Ceramic tile: 20,000 square feet 

Vinyl composite tile (VCT): 25,000 square feet 

The flooring material costs are asfollows: 

Stained concrete: $$6.00/sq ft 

Sealed concrete: $$2.00/sq ft 

Carpet: $$8.75/sq ft 

Ceramic tile: $$15.00/sq ft 

VCT: $$5.75/sq ft 

Vinyl plank flooring: $7.00/sq ft 

Which of the following combinations of changes results in these savings?

An architect is designing a school building that features a flat roof with a low parapet wall in a wet 

climate region. The client wants to minimize maintenance requirements and focus on keeping water 

from the walls. 

What parapet coping detail would be most appropriate for the architect to select for this project?

story height in any direction. The door can tolerate a maximum departure from vertical of 1/4 inch. 

What isthe maximum height the door can be to accommodate the story drift?

An architect is designing a multipurpose room that will operate daycare services as well as exercise 

classes. The multiple occupancies within the space utilize components of the same means of egress 

system. 

What is the occupant load factor that should be used in calculating egress?

critical path due to which of the following?

ceiling plenum spaces should be cross-checked with the mechanical engineer and which one of the 

following?

room?

Which of the following correctly identifies the types of failures indicated in the beam diagram?

entrance?

that the outflow invert at one manhole was 120 feet and the inflow invert at the next manhole, 

which is 200 feet downstream, was 117 feet. 

What is the percentage of slope between the two manholes?

should result in which one of the following?

of the following?

panelsis which one of the following?