Refer to the exhibit.

The partial output of FortiOS kernel slabs is shown.

Which statement about total slab size is true? (Choose one answer)

Refer to the exhibit.

The output of the command diagnose vpn tunnel list is shown.

Reviewing the debug command, what is the current status of the traffic flowing through the tunnel? (Choose one answer)

Refer to the exhibit.

An IPsec VPN tunnel using IKEv2 was brought up successfully, but when the tunnel rekey takes place the tunnel goes down.

The debug command for IKE was enabled and, in the exhibit, you can review the partial output of the debug IKE while attempting to bring the

tunnel up.

What is causing the tunnel to be down? (Choose one answer)

The output of the get router info bgp summary command is shown.

Which statement regarding adjacencies between the local router and its neighbors is correct? (Choose one answer)

An administrator has configured a firewall policy to use proxy-based inspection mode.

What could explain the messages observed in the debug flow output? (Choose one answer)

Refer to the exhibit.

Partial output of command diagnose debug rating command is shown.

Which FDS server will the FortiGate algorithm choose? (Choose one answer)

Refer to the exhibits.

FGT-1 is an area border router (ABR) that has interfaces in OSPF areas 0.0.0.0 and 0.0.0.5. FGT-3 acts as an autonomous system border router

(ASBR), importing static routes into OSPF. FGT-2 is an internal router with all its interfaces belonging to area 0.0.0.5. FGT-1 is receiving all

advertised routes from FGT-2, however, FGT-3 is not receiving any of the advertised routes from FGT-1.

What is the most likely reason for this? (Choose one answer)

Refer to the exhibit

The partial output of diagnose sys session stat command is shown.

Which statement about the output shown in the exhibit is correct? (Choose one answer)

Refer to the exhibit

The output of a BGP debug command is shown.

Why has the local router at 172.16.23.58 been unable to establish adjacency with its only neighbor? (Choose one answer)

process to the service provider (SP)? (Choose one answer)

Refer to the exhibit.

The output of diagnose sys session list command is shown.

If the HA ID for the primary device is 0, what happens if the primary fails and the secondary becomes the primary? (Choose one answer)

Refer to the exhibit.

What is the most likely reason that the local FortiGate is not receiving any prefixes from its neighbors? (Choose one answer)

Refer to the exhibit.

Which type of policy route does the output show? (Choose one answer)

Refer to the exhibit.

The exhibit shows a session entry.

Which statement about this TCP session is true? (Choose one answer)

Refer to the exhibit.

If the default settings are in place, what can you conclude about the conserve mode shown in the exhibit? (Choose one answer)

Refer to the exhibit.

An IPsec VPN tunnel is dropping, as shown by the debug output.

Analyzing the debug output, what could be causing the tunnel to go down? (Choose one answer)

Refer to the exhibit.

The administrator did not override the FortiGuard FQDN or IP address in the FortiGate configuration.

Which IP address did FortiGate get when resolving the service.fortiguard.net name? (Choose one answer)