The following configuration was created on the switch:（含图）

using spanning tree configuration with Aruba CX 8360-32YC switches.

What is the benefit of VSX clustering with the new solution?

security audit on their network, they discovered that the tunnels built between the CX switch and the

Aruba Gateway are not encrypted. The company is concerned that bad actors could try to insert spoofed

messages on the Gateway to disrupt communications or obtain information about the network.

Which action must the administrator perform to address this situation?

switches with dedicated management ports?

CX 8325 as a collapsed core 802 1X is implemented for authentication. Due to the lack of cabling, some

unmanaged switches are still in use Sometimes devices behind these switches cause network outages

The switch should send a warning to the helpdesk when the problem occurs You have been asked to

implement an effective solution to the problem.

What is the solution for this?

route for your network Traffic originating from 10.2.250.0/24 should use a new default route to

10.1.1.253. Other non-default routes for this subnet should not be affected by this change.

What are two parts of the solution for these requirements? (Select two.)

attach to them An SVI interface is configured for VLAN 10 and serves as the default gateway for VLAN

10. The ISL link between the switches fails, but the keepalive interface functions. Active gateway has

been configured on the VSX switches.（含图）What is correct about access from the servers to the Core? (Select two.)

How should you establish the keepalive connection?

(The sensor has no cellular connection)

separate routing table?

* All machines are connected via Aruba CX6200 switches in VLANs 100.110. and 120

* Several external technicians are maintaining this special equipment

What are the correct commands to ensure that no rogue DHCP server will impact the network?

join the network and the WLAN is configured with OWE?

(DSCP).

keep this application working across the campus which is connected via layer-3. The legacy devices are

connected to Aruba CX 6300 switches throughout the campus.

Which technology minimizes flooding so the legacy application can work efficiently?